Vortex Scope Caps – MK Machining

MK Machining is excited to offer Vortex Scope Caps. Our scope caps are made out of a Nylon 11 material using an HP MJF 5200 3D Printer. Nylon 11 is slightly flexible to fit over your scope objective without becoming brittle and is strong enough to handle wear and tear. Scope caps feature a custom made spring for full range opening and closing of the cap without unnecessary noise. Caps slip over the objective and are tightened down using a single bolt. Compatible with MK Machining ARDs

This Objective Cap has been tested to work with following  Vortex scopes:

Vortex Diamondback Tactical 44mm

Vortex Diamondback Tactical 50mm

Vortex Razor AMG 6-24×50

Vortex Razor HD Gen II 3-18×50

Vortex Razor HD Gen II 4.5-27×56

Vortex Razor HD Gen III 1-10x

Vortex Razor LHT 3-15×42

Vortex Razor LHT 4.5-22×50

Vortex Strike Eagle 24mm

Vortex Strike Eagle 5-25×56

Vortex Venom 5-25×56

Vortex VIPER PST Gen I 2.5-10X32 

Vortex Viper PST Gen I 4-16×50

Vortex Viper PST Gen II 3-15×44

Vortex Viper PST Gen II 5-25×50

Vortex Viper PST Gen II 5-25×56

These scope caps will only fit the listed Vortex scopes. If you are unsure of which one to order contact [email protected] for assistance.