General DescriptionMAX 7000A (including MAX 7000AE) devices are high-density, highperformance devices based on Altera’s second-generation MAX architecture. Fabricated with advanced CMOS technology, the EEPROMbased MAX 7000A devices operate with a 3.3-V supply voltage and provide 600 to 10,000 usable gates, ISP, pin-to-pin delays as fast as 4.5 ns, and counter speeds of up to 227.3 MHz. MAX 7000A devices in the -4, -5, -6, -7, and some -10 speed grades are compatible with the timing requirements for 33 MHz operation of the PCI Special Interest Group (PCI SIG) PCI Local Bus Specification, Revision 2.2. See Table 2.

Features...■ High-performance 3.3-V EEPROM-based programmable logic devices (PLDs) built on second-generation Multiple Array MatriX (MAX®) architecture (see Table 1)■ 3.3-V in-system programmability (ISP) through the built-in IEEE Std. 1149.1 Joint Test Action Group (JTAG) interface with advanced pin-locking capability    – MAX 7000AE device in-system programmability (ISP) circuitry compliant with IEEE Std. 1532    – EPM7128A and EPM7256A device ISP circuitry compatible with IEEE Std. 1532■ Built-in boundary-scan test (BST) circuitry compliant with IEEE Std. 1149.1■ Supports JEDEC Jam Standard Test and Programming Language (STAPL) JESD-71■ Enhanced ISP features    – Enhanced ISP algorithm for faster programming (excluding EPM7128A and EPM7256A devices)    – ISP_Done bit to ensure complete programming (excluding EPM7128A and EPM7256A devices)    – Pull-up resistor on I/O pins during in-system programming■ Pin-compatible with the popular 5.0-V MAX 7000S devices■ High-density PLDs ranging from 600 to 10,000 usable gates■ Extended temperature range■ 4.5-ns pin-to-pin logic delays with counter frequencies of up to227.3 MHz■ MultiVoltTM I/O interface enables device core to run at 3.3 V, while I/O pins are compatible with 5.0-V, 3.3-V, and 2.5-V logic levels■ Pin counts ranging from 44 to 256 in a variety of thin quad flat pack (TQFP), plastic quad flat pack (PQFP), ball-grid array (BGA), spacesaving FineLine BGATM, and plastic J-lead chip carrier (PLCC) packages■ Supports hot-socketing in MAX 7000AE devices■ Programmable interconnect array (PIA) continuous routing structure for fast, predictable performance■ PCI-compatible■ Bus-friendly architecture, including programmable slew-rate control■ Open-drain output option■ Programmable macrocell registers with individual clear, preset, clock, and clock enable controls■ Programmable power-up states for macrocell registers in MAX 7000AE devices■ Programmable power-saving mode for 50% or greater power reduction in each macrocell■ Configurable expander product-term distribution, allowing up to 32 product terms per macrocell■ Programmable security bit for protection of proprietary designs■ 6 to 10 pin- or logic-driven output enable signals■ Two global clock signals with optional inversion■ Enhanced interconnect resources for improved routability■ Fast input setup times provided by a dedicated path from I/O pin to macrocell registers■ Programmable output slew-rate control■ Programmable ground pins