怎么看交换机接口是否存在错误包

您好，请知：

可以使用dis int gi 1/0/1类似的命令查看

[H3C]dis int gi 1/0/1

GigabitEthernet1/0/1Current state: DOWNLine protocol state: DOWNDescription: GigabitEthernet1/0/1 InterfaceMaximum transmission unit: 1500Internet protocol processing: DisabledIP packet frame type: Ethernet II, hardware address: 4ce9-e4b5-2259IPv6 packet frame type: Ethernet II, hardware address: 4ce9-e4b5-2259Media type is twisted pair, loopback not set, promiscuous mode not setSpeed Negotiation, Duplex Negotiation, link type is autonegotiationOutput flow-control is disabled, input flow-control is disabledLast link flapping: NeverLast clearing of counters: NeverPeak input rate: 0 bytes/sec, at 00-00-00 00:00:00 Peak output rate: 0 bytes/sec, at 00-00-00 00:00:00 Last 300 second input: 0 packets/sec 0 bytes/sec -%Last 300 second output: 0 packets/sec 0 bytes/sec -%Input (total): 0 packets, 0 bytes0 unicasts, 0 broadcasts, 0 multicasts, 0 pausesInput (normal): 0 packets, 0 bytes0 unicasts, 0 broadcasts, 0 multicasts, 0 pausesInput: 0 input errors, 0 runts, 0 giants, - throttles0 CRC, 0 frame, 0 overruns, 0 aborts0 ignored, - parity errorsOutput (total): 0 packets, 0 bytes0 unicasts, 0 broadcasts, 0 multicasts, 0 pausesOutput (normal): 0 packets, 0 bytes0 unicasts, 0 broadcasts, 0 multicasts, 0 pausesOutput: 0 output errors, 0 underruns, - buffer failures0 aborts, 0 deferred, 0 collisions, 0 late collisions0 lost carrier, 0 no carrier

端口入方向报文计数错误字段解释 input errors：各种输入错误的总数。runts：表示接收到的超小帧个数。超小帧即接收到的报文小于 64 字节，且包括有效的 CRC 字段，报文格式正确。 giants：是超过端口设置的 Maximum Frame Length 的报文个数。 CRC：表示接收到的 CRC 校验错误报文个数。frame：端口接收时出错的报文。端口出方向报文计数错误字段解释 output errors：各种输出错误的总数。aborts：表示发送失败的报文总数。 deferred：表示延迟报文的总数。报文延迟是指因延迟过长的周期而导致发送失败的报文，而这些报文由于发送媒质繁忙而等待了超过 2 倍的最大报文发送时间。collisions：表示冲突帧总数，即在发送过程中发生冲突的报文。 late collisions：表示延迟冲突帧，即发送过程中发生延迟冲突超过 512bit 时间的帧。