USG2260双机热备配置后主备不断切换问题 | 您所在的位置:网站首页 › 双机热备hrp › USG2260双机热备配置后主备不断切换问题 |
1. 检查光纤和光模块都是没有问题的,用到别的设备上面都工作正常; 2. 时钟的信号记录正常,同步工作; 3. 环回口的测试正常; 4. 与其它设备的固定正常网口相连都没有问题,就是板卡之间连接的网口有问题; 记录接口信息: display interface GigabitEthernet 5/0/19 20:16:16 2015/06/26 GigabitEthernet5/0/19 current state : UP Line protocol current state : UP Description : Huawei, USG2200 Series, GigabitEthernet5/0/19 Interface, Lan Switch Port The Maximum Transmit Unit is 1500 bytes, Hold timer is 10(sec) Eth-Trunk number: 1 Media type is optical fiber, loopback is not set, promiscuous mode not set 1000Mb/s-speed mode, Full-duplex mode, link type is auto negotiation flow control is disable Optical Transceiver Module is set VendorName:FINISAR CORP. Compliance:1000BASE-SX PartNumber:FTLF8519P3BTLHW1 SN:NRQ2LH3 Mode:Unknown or unspecified Connector:LC LaserwaveLen:850nm Length for 50/125um:500m Rate:2100Mb/s Current SFP module Tx power( |
CopyRight 2018-2019 实验室设备网 版权所有 |