SetScrollSizes( nMapMode, GetDocument( )

void SetScrollSizes( int nMapMode, SIZE sizeTotal, const SIZE& sizePage = sizeDefault, const SIZE& sizeLine = sizeDefault );

Parameters

nMapMode

The mapping mode to set for this view. Possible values include:

All of these modes are defined by Windows. Two standard mapping modes, MM_ISOTROPIC and MM_ANISOTROPIC, are not used for CScrollView. The class library provides the SetScaleToFitSize member function for scaling the view to window size. Column three in the table above describes the coordinate orientation.

sizeTotal

The total size of the scroll view. The cx member contains the horizontal extent. The cy member contains the vertical extent. Sizes are in logical units. Both cx and cy must be greater than or equal to 0.

sizePage

The horizontal and vertical amounts to scroll in each direction in response to a mouse click in a scroll-bar shaft. The cx member contains the horizontal amount. The cy member contains the vertical amount.

sizeLine

The horizontal and vertical amounts to scroll in each direction in response to a mouse click in a scroll arrow. The cx member contains the horizontal amount. The cy member contains the vertical amount.

Remarks

Call SetScrollSizes when the view is about to be updated. Call it in your override of the OnUpdate member function to adjust scrolling characteristics when, for example, the document is initially displayed or when it changes size.

You will typically obtain size information from the view’s associated document by calling a document member function, perhaps called GetMyDocSize, that you supply with your derived document class. The following code shows this approach:

Alternatively, you might sometimes need to set a fixed size, as in the following code:

You must set the mapping mode to any of the Windows mapping modes except MM_ISOTROPIC or MM_ANISOTROPIC. If you want to use an unconstrained mapping mode, call the SetScaleToFitSize member function instead of SetScrollSizes.

Example