麒麟系统升级openssh至9.5p1

2024-06-17 07:47| 来源: 网络整理| 查看: 265

当前环境：

升级openssh需要三个包zlib-1.2.13.tar.gz、openssl-1.1.1t.tar.gz、openssh-9.5p1.tar.gz

下载地址：

zlib-1.2.13.tar.gz http://zlib.net/fossils/zlib-1.2.13.tar.gz

openssl-1.1.1t.tar.gz https://www.openssl.org/source/old/1.1.1/openssl-1.1.1t.tar.gz

openssh-9.5p1.tar.gz https://ftp.openbsd.org/pub/OpenBSD/OpenSSH/openssh-9.5.tar.gz

开始安装

安装顺序zlib->openssl->openssh

//安装 zlib tar zxvf zlib-1.2.13.tar.gz cd zlib-1.2.13 ./configure --prefix=/usr/local/zlib make && make install //安装 openssl cd .. tar zxvf openssl-1.1.1t.tar.gz cd openssl-1.1.1t ./config --prefix=/usr/local/ssl -d shared make && make install echo '/usr/local/ssl/lib' >> /etc/ld.so.conf //安装 openssh cd .. yum -y remove openssh tar zxvf openssh-9.5p1.tar.gz cd openssh-9.5p1 ./configure --prefix=/usr/local/openssh --with-zlib=/usr/local/zlib --with-ssl-dir=/usr/local/ssl --without-openssl-header-check make && make install //配置 echo 'PermitRootLogin yes' >> /usr/local/openssh/etc/sshd_config echo 'PubkeyAuthentication yes' >> /usr/local/openssh/etc/sshd_config echo 'PasswordAuthentication yes' >> /usr/local/openssh/etc/sshd_config cd contrib/redhat/ cp sshd.init /etc/init.d/sshd chkconfig --add sshd cp /usr/local/openssh/etc/sshd_config /etc/ssh/sshd_config cp /usr/local/openssh/sbin/sshd /usr/sbin/sshd cp /usr/local/openssh/bin/ssh /usr/bin/ssh cp /usr/local/openssh/bin/ssh-keygen /usr/bin/ssh-keygen \cp /usr/local/openssh/etc/ssh_host_ecdsa_key.pub /etc/ssh/ssh_host_ecdsa_key.pub systemctl start sshd.service chkconfig --add sshd chkconfig sshd on

安装完成后

【本文地址】

公司简介

联系我们