LinuxCNC Users Manual for Beginners

2024-07-09 21:00| 来源: 网络整理| 查看: 265

I have already install the LinuxCNC in my desktop along with Linux Mint and that鈥檚 where I do my learning now. When I feel more comfortable, I will buy a new (used) desktop dedicated for my workshop where my cnc is located and then the REAL learning will start. As far as I know I see no need to have the ISO on a USB since there is only one LinuxCNC to learn, I mean there is no alternative.

My 3 axis 4 motors cnc runs now on Mach3. When I remove Mach3 and install LinuxCNC would all electronics I now have be suitable or LinuxCNC requires special electronics (like stepper motors, motor drivers, breakout board and spindle control?)

I found a link here dated April 2015 and it talks about parts I鈥檓 not aware.

If I need new electronics for the LinuxCNC where should I look for them in USA/Canada?

【本文地址】

公司简介

联系我们