|
This information is provided to help you when it is difficult to remove the table-top stand in order to change the height and position of the table-top stand, mount the TV on a wall, or re-box the TV.
Notes:
For 2022 models, see the article Change the height and position of the table-top stand for my Google TV.This information is only for the following 2021 model series:
X90J_X91J_X92J_X93J_X94J (50”/55”/65”/75”)X85J_X86J_X89J (43”/50”/55”/65”/75”/85”)X79J_X80J_X81J_X82J (43”/50”/55”/65”/75”)
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY OR PROPERTY DAMAGE
Before you start
Three or more people are required to handle the TV to detach the stands.A standard flat-head screwdriver is required to detach the stand. It's recommended to add tape to the tip of the screwdriver to prevent scratching the TV.
Avoid using excessive force while detaching the table-top stands from the TV as it may cause the TV to fall resulting in personal injury or physical damage to the TV.As you detach the table-top stands, be careful when lifting the TV because the table-top stand may fall and cause injury or damage to the surface that the TV is sitting on.If you are mounting the TV on a wall, make sure all mounting hardware is installed on the back of the TV and the wall prior to removing the stands.
Instructions to remove the stand
Instructions are provided to remove the table-top stand from an upright position or when lying face down. Follow the instructions for the desired method.
Remove the stands with the TV in an upright position
Lift one side of the TV.
Using a standard flat-head screwdriver, insert it vertically into the stand insertion slot at the bottom of the TV.
Pry the stand loose by pushing the screwdriver handle up towards the TV screen side until the stand comes out a little from the insertion slot.
Pull the table-top stand out of the insertion slot by hand.
Repeat the steps necessary for the other side.
Remove the stand with the TV on a flat surface (43”/50” only)
Prepare a table covered with a soft cloth to protect the TV screen from scratches or damage.Gently place the TV with the LCD screen side down onto the table covered with a soft cloth.
Using a standard flat-head screwdriver, insert it horizontally into the stand insertion slot at the bottom of the TV.
Pry the stand loose by pushing the screwdriver handle down towards the TV screen side until the stand comes out a little from the insertion slot.
Pull the table-top stand out of the insertion slot by hand.
Repeat the steps necessary for the other side.
Note: Be sure to store the removed stands in a safe place in case you want to use the TV on a table in the future. The table-top stands cannot be purchased separately.
|