|
华为-配置LACP模式的链路聚合
[HUAWEI] interface eth-trunk 1
[HUAWEI-Eth-Trunk1] mode lacp
[HUAWEI-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/3
[HUAWEI-Eth-Trunk1] port link-type trunk
[HUAWEI-Eth-Trunk1] port trunk allow-pass vlan 10 20
[HUAWEI-Eth-Trunk1] quit
华三-二层静态聚合配置举例
1、# 创建二层聚合接口1
[H3C] interface bridge-aggregation 1
[H3C-Bridge-Aggregation1] quit
2、# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。
[H3C] interface gigabitethernet 1/0/1
[H3C-GigabitEthernet1/0/1] port link-aggregation group 1
[H3C-GigabitEthernet1/0/1] quit
[H3C] interface gigabitethernet 1/0/2
[H3C-GigabitEthernet1/0/2] port link-aggregation group 1
[H3C-GigabitEthernet1/0/2] quit
[H3C] interface gigabitethernet 1/0/3
[H3C-GigabitEthernet1/0/3] port link-aggregation group 1
[H3C-GigabitEthernet1/0/3] quit
3、# 配置二层聚合接口1为Trunk端口，并允许VLAN 100的报文通过。
[H3C] interface bridge-aggregation 1
[H3C-Bridge-Aggregation1] port link-type trunk
[H3C-Bridge-Aggregation1] port trunk permit vlan 100
[H3C-Bridge-Aggregation1] quit
思科配置链路聚合
进入全局模式：Switch#conf t 进入交换机接口：Sw1(config)#int range f0/1-2 更改接口传输模式：Sw1(config-if)#switchport mode trunk 将接口绑定链路聚合1：Sw1(config-if-range)#channel-group 1 mode on 允许所有vlan通过：Sw1(config-if)#switchport trunk allowed vlan all
|