华为eNSP模拟酒店无线wifi实验

酒店AC+AP无线网络覆盖解决方案 每个房间采用面板上ap，房间走道采用吸顶式ap，AC统一管理。 瘦 AP和无线控制器系统有非常强大的集中管理功能，所有的关于无线网络的配置都可以通过配置无线控制器器统一完成。 每层楼的ap都接到各层楼的POE交换机

华为AC官方手册：http://support.huawei.com/hedex/hdx.do?docid=EDOC1000121401&lang=zh

逻辑拓扑如下：

管理vlan： 200 业务vlan：100

DHCP服务器： AC为AP分配地址:192.168.200.0/24 ， 汇聚层SW为客户端分配地址172.16.0.1/22

AC其他详情配置，请参考官方手册：

POE交换机设置：

[POE]vlan batch 100 200

interface Ethernet0/0/1 description POE to SW port link-type trunk port trunk allow-pass vlan 100 200

interface Ethernet0/0/2 description POE to AP port link-type trunk port trunk pvid vlan 200 port trunk allow-pass vlan 100 200 port-isolate enable group 1

SW核心交换机配置：

vlan batch 100 200 300

interface GigabitEthernet0/0/1 description SW to POE port link-type trunk port trunk allow-pass vlan 100 200 300

interface GigabitEthernet0/0/23 description SW to AC port link-type trunk port trunk allow-pass vlan 100 200

[SW]dhcp enable

interface GigabitEthernet0/0/24 description SW to FW port link-type access port default vlan 300

interface Vlanif100 ip address 172.16.0.1 255.255.252.0 dhcp select interface dhcp server dns-list 114.114.114.114 223.5.5.5

interface Vlanif 300 ip address 192.168.100.253 255.255.255.0

ip route-static 0.0.0.0 0.0.0.0 192.168.100.254 #设置默认路由指向防火墙

AC配置： vlan batch 100 200

interface GigabitEthernet0/0/1 port link-type trunk port trunk allow-pass vlan 100 200

[AC]dhcp enable

interface Vlanif200 ip address 192.168.200.254 255.255.255.0 dhcp select interface dhcp server dns-list 114.114.114.114 223.5.5.5

[AC]wlan [AC-wlan-view]ap-group name ap-group1 [AC-wlan-ap-group-ap-group1]quit

[AC-wlan-view]regulatory-domain-profile name default [AC-wlan-regulate-domain-default]country-code cn [AC-wlan-regulate-domain-default]quit

[AC-wlan-view]ap-group name ap-group1 [AC-wlan-ap-group-ap-group1]regulatory-domain-profile default Warning: Modifying the country code will clear channel, power and antenna gain c onfigurations of the radio and reset the AP. Continue?[Y/N]:y [AC-wlan-ap-group-ap-group1]quit [AC-wlan-view]quit

[AC]capwap source interface Vlanif 200 （这里的vlan 是管理ap的vlan）

ap auth-mode命令缺省情况下为MAC认证，如果之前没有修改其缺省配置，可以不用执行ap auth-mode mac-auth。

[AC]wlan [AC-wlan-view] ap auth-mode mac-auth [AC-wlan-view] ap-id 0 ap-mac 00e0-fc51-6e60 [AC-wlan-ap-0]ap-name area_1 [AC-wlan-ap-0]ap-group ap-group1 Warning: This operation may cause AP reset. If the country code changes, it will clear channel, power and antenna gain configurations of the radio, Whether to c ontinue? [Y/N]:y [AC-wlan-ap-0] quit

[AC-wlan-ap-0]display ap all 查看上线的ap

[AC-wlan-view]security-profile name laotang [AC-wlan-sec-prof-laotang]security wpa-wpa2 psk pass-phrase a1234567 aes [AC-wlan-sec-prof-laotang]quit

[AC-wlan-view]ssid-profile name laotang [AC-wlan-ssid-prof-laotang]ssid laotang [AC-wlan-ssid-prof-laotang]quit

[AC-wlan-view]vap-profile name laotang [AC-wlan-vap-prof-laotang]forward-mode direct-forward [AC-wlan-vap-prof-laotang]service-vlan vlan-id 100 [AC-wlan-vap-prof-laotang]security-profile laotang [AC-wlan-vap-prof-laotang]ssid-profile laotang [AC-wlan-vap-prof-laotang]quit

[AC-wlan-view]ap-group name ap-group1 [AC-wlan-ap-group-ap-group1]vap-profile laotang wlan 1 radio 0 [AC-wlan-ap-group-ap-group1]vap-profile laotang wlan 1 radio 1 [AC-wlan-ap-group-ap-group1]quit

[AC-wlan-view] display vap ssid wlan-net 查询

此时的ap已经开放信号了

笔记本已经可以连上了

接着配置防火墙，路由器，因为华为模拟器防火墙支持web端配置，所有这里我们采用web端配置。 游览器输入管理地址进行配置（建议用火狐） 1.根据快速向导进行配置 2.选择手动时间 3.根据实际情况选择上网模式 4.根据实际情况选择局域网接口 5.由于我的核心交换机已经配置好dhcp，这里就不需要开启dhcp了 6.向导已经完成了

7.接下来把防火墙的策略打开 8.然后设置nat进行转换

ip route-static 172.16.0.0 255.255.252.0 192.168.100.253 设置静态路由指向核心交换机 接口模式下允许ping： service-manage ping permit

由于我的破笔记本太渣了， 中途死机了， 导致实验中断， 后面不能测试！！！！