挠度是什么意思 您所在的位置:网站首页 bending英语怎么读 挠度是什么意思

挠度是什么意思

2024-05-30 23:38| 来源: 网络整理| 查看: 265

全部

Compatibility will require that the girder deflection at B be zero.

根据协调性的要求,梁在B点的挠度应为零.

辞典例句

Excessive deflection in a structure may cause considerable damage to cladding.

结构的过大挠度可以引起覆盖面的巨大破坏.

辞典例句

We may use the plane stress analysis for determining deflections in the midplane of the beam.

我们可以用平面压力的分析方法来确立梁中间面的挠度.

辞典例句

Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.

垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度,来承担足够的荷载.

辞典例句

In the analysis of plates in bending, deflection is obtained by solving Eq.

在受弯板的分析中, 借求解满足板边界处条件的方程得出挠度.

辞典例句

The deflection of filaments between two fulcrums was analyzed.

摘要分析了两种情况下的丝线的挠度.

互联网

Then based on deflection theory, research was focused on its mechanical property.

在简要介绍自锚式悬索桥特点以后, 着重从挠度理论出发研究其力学特性.

互联网

Rotational deformation of the shaft will produce maximum deflection.

转动的泵轴会弯曲变形,产生最大挠度.

互联网

While at the corner there are corner conditions: deflection or reaction also.

沿每个边有两个边界条件: 挠度或等效剪力,斜度或弯矩应分别等于沿边界的已给值.

互联网

The changes of deflection, prestress and reactions with temperature increasing are presented.

主要测试了构件的挠度变化 、 预应力的变化及支座反力的变化.

互联网

The equivalent elastic modulus was deduced by comprehensive considering deflection and elastic modulus.

通过综合考虑挠度引起弹性模量和弹性伸长引起弹性模量推导出等效弹性模量.

互联网

At the same time, a formula is given for calculating the deflection under short - term load effect.

同时, 通过对比研究,给出了板在荷载 短期 效应作用下的挠度计算公式.

互联网

Deflection measurement results of bridge at Taolaizhao across the Songhuajiang river are analyzed in this paper.

分析了陶赖昭松花江特大桥挠度测量结果.

互联网

How to estimate creep stress from small punch creep test results was described in present paper.

主要阐述根据小冲杆试样实测中心挠度求蠕变应力的问题.

互联网

This is further aggravated by cracking, which reduces the flexural stiffness of members.

开裂降低了构件的弯曲刚度, 这会进一步使挠度增大.

互联网



【本文地址】

公司简介

联系我们

今日新闻

    推荐新闻

    专题文章
      CopyRight 2018-2019 实验室设备网 版权所有